Blackbird Sims / Milviz Forum Archive

Hello everybody,

1- Is it possible to lock the tail wheel ?

2- How can I set the second digit of the NAV. other than 2, 3 or 7 ? I would like the set at zero or five. (ex 110.50 instead od 110.53)

BugDani.

Hello BugDani , there is no tailwheel lock on the DHC2 but you could configure one by adding tailwheel_lock = 1 into the [contact_point] section of the aircraft.cfg.

In theory if you reset the aircraft your radio frequency will have a 0 or 5 as the last number , its going to remember the last frequency set or default to 110.53 and increment in five kHz , an fsx bug in that the radio frequencies change in that cadence .

In a worst case scenario setting these on one of the mv gns units breaks that cycle once you switch back to the Bendix King units .

Hope that helps.

Best CJ