Blackbird Sims / Milviz Forum Archive

Hello,

The issue is that I'can't move on the ground even with full power and both normal or tundra wheels ( And even with floats on water !!! )
It look like the chocks are not removed
If I go to the sky in slew mode, then I land and taxy, all is mormal till the speed come to zero!
Indeed, If I stop the plane: Impossible to move again!
All is in good position in MVAMS: Ready to fly and even visual is without chocks.

When I set full power on the ground, the plane try to move forward but stay in place with the tail going left and right with rudder action... AND.... the wheels are running on place !!!!

* If I set full power, the speed come alive on the panel, the tail lift off at 60kts, and I CAN TAKE OFF AND FLY BUT ON PLACE !!! INCREDIBLE!

Any help is welcome

Dani. (P3Dv4)

Hi,

Are you using a joysitck controller for your brakes? If so, check for possible noise because if brakes are not completely released (position at 0), the Beaver will behave like with chokes on.
Otherwise please give more info on how do you begin your flights, etc.

Tom

Hello, all is already answered.

- If I set full power, the speed come alive on the panel, the tail lift off at 60kts, and I CAN TAKE OFF AND FLY BUT ON PLACE !!! INCREDIBLE!
All look normal but always in the same place: The landscape doesn't move !!!

-To go to the sky it is only in slew mode, then release "Y" ! Then I can fly, land and taxi, all is mormal till the speed come to zero!

Dani.

Sorry but I'm back again!

I'm very frustrated cause I cannot use my very new Beaver!
I'haven't no problem with other aircraft. Even My T-38 and My F-4e work well.

One week since I've got this Beaver bu NO HELP AT ALL !!!

May be , I have to delete it and forget my money?

Bug.

@Taguilo please check further. I think this one is beyond most of the devs.

Unplug your device and use the keyboard to fly. If it works... then your problem is the device... if it doesn’t, then we will look at this further.

Not quite. Something odd is happening here if you read carefully. He is able to lift off and fly, pitch/roll/yaw the aircraft, without it even moving from its geographical location. Kinda like a helicopter that can't go anywhere except up or down.

He should try it anyway... (read taguilo's post)

That shouldn't be a factor at all in what he is describing. Something is going seriously wrong with his simulator as a whole, not just a braking glitch.

bugdani wrote:Sorry but I'm back again!

I'm very frustrated cause I cannot use my very new Beaver!
I'haven't no problem with other aircraft. Even My T-38 and My F-4e work well.

One week since I've got this Beaver bu NO HELP AT ALL !!!

May be , I have to delete it and forget my money?

Bug.

I cannot reproduce your issue at all.
As Colin stated, try removing all devices and use the keyboard as a first test.
Also start P3D in opening free flight screen, not in a saved aircraft (and location).

Tom

Also might be helpful to post your dll.xml so we can determine what addons you may be using.

Thank you so much!

It's OK now!
I have disconnect and reconnect my ch stick and suddenly it work!

My next problem is to understand why extra paint are black on right hand flap and horizontal tail...

Anyway, thanks for help!

BugDani.

bugdani wrote:My next problem is to understand why extra paint are black on right hand flap and horizontal tail...

That would be because those are extra paint's are obsolete.