Page 1 of 1
Updated aircraft has reverse trim??
Posted: Wed Aug 30, 2017 9:31 pm
by Tinian
I have not been able to use FSX much lately. I thought I would fly the Beaver and noticed some repaints missing. Found them in an old saved folder, so I must have updated. Coming out of KFHR I needed to trim down a bit using the Saitek Cessna trim. I have an ez-dok shot aimed at the trim on the ceiling panel , but the indicator is going trim up and I am trimming down and going down???
Re: Updated aircraft has reverse trim??
Posted: Thu Aug 31, 2017 3:08 pm
by Chuck Jodry
The latest 170829 versions should take care of that item , it happened one these became servo driven but has since been rectified , running the MVAMS should let you know if the version you are running has an update , be warned that the mapping is revised and the older repaints will need updating .
Best CJ
Re: Updated aircraft has reverse trim??
Posted: Thu Dec 28, 2017 4:04 pm
by Eric Bakker
Chuck Jodry wrote:The latest 170829 versions should take care of that item
Best CJ
Hi Chuck,
I just found today that with the STOL versions the trim indicator still goes the wrong way.