Updated aircraft has reverse trim??

Locked
Tinian
Posts: 11
Joined: Mon Jun 26, 2017 5:02 pm
Updated aircraft has reverse trim??

Post by Tinian » Wed Aug 30, 2017 9:31 pm

I have not been able to use FSX much lately. I thought I would fly the Beaver and noticed some repaints missing. Found them in an old saved folder, so I must have updated. Coming out of KFHR I needed to trim down a bit using the Saitek Cessna trim. I have an ez-dok shot aimed at the trim on the ceiling panel , but the indicator is going trim up and I am trimming down and going down???
Top
Chuck Jodry
Posts: 442
Joined: Mon Dec 20, 2010 4:30 pm
Re: Updated aircraft has reverse trim??

Post by Chuck Jodry » Thu Aug 31, 2017 3:08 pm

The latest 170829 versions should take care of that item , it happened one these became servo driven but has since been rectified , running the MVAMS should let you know if the version you are running has an update , be warned that the mapping is revised and the older repaints will need updating .

Best CJ
Top
Eric Bakker
Posts: 33
Joined: Sun May 18, 2014 3:15 pm
Location: Netherlands
Re: Updated aircraft has reverse trim??

Post by Eric Bakker » Thu Dec 28, 2017 4:04 pm

Chuck Jodry wrote:The latest 170829 versions should take care of that item
Best CJ
Hi Chuck,

I just found today that with the STOL versions the trim indicator still goes the wrong way.
Top
Locked

Return to “DHC-2 Beaver Support Forum”