Page 1 of 1
Prop lever not working with my hardware
Posted: Mon Jun 26, 2017 12:01 am
by GlennH
Ch throttle assigned to prop 1 for blue lever 1 via fsuipc (as per all my controls) and the lever doesn't function. Throttle and mixture works fine.
This is the standard mapping I use for all other addons with no issues.
Any ideas?
Thanks
Glenn
Re: Prop lever not working with my hardware
Posted: Mon Jun 26, 2017 3:11 pm
by Taguilo
Hi,
Do you have Beaver's latest version?
You can map prop lever using FS's default "Controls..." menu.
In FSUIPC you must select "Send to FS as norma axis", and then select 'Axis Propeller1 Set" in the first combo.
Tom
Re: Prop lever not working with my hardware
Posted: Mon Jun 26, 2017 7:33 pm
by GlennH
Ok, will try that. Right now my FUSIPC GA setup sends all axis to FSUIPC for calibration.
Sounds like I need to use a new specific profile for the Beaver........
Re: Prop lever not working with my hardware
Posted: Tue Jun 27, 2017 11:52 am
by cavaricooper
If there is capacity, please consider allowing it to work with Throttle & Prop as well as Throttle 1 & Prop 1. I know of at least one other well known GA developer that requires Throttle (and specifically NOT Throttle 1).
Ta!
Carl
Re: Prop lever not working with my hardware
Posted: Tue Jun 27, 2017 3:39 pm
by Taguilo
cavaricooper wrote:If there is capacity, please consider allowing it to work with Throttle & Prop as well as Throttle 1 & Prop 1. I know of at least one other well known GA developer that requires Throttle (and specifically NOT Throttle 1).
Ta!
Carl
Throttle control is default, no custom coded.
Beaver's latest version already has
axis propeller and
axis propeller1 events captured so any of these can be used to control the lever.
Tom
Re: Prop lever not working with my hardware
Posted: Tue Jun 27, 2017 9:32 pm
by cavaricooper
Ta Tom- appreciated!
Carl