Prop lever not working with my hardware

[GlennH]

Ch throttle assigned to prop 1 for blue lever 1 via fsuipc (as per all my controls) and the lever doesn't function. Throttle and mixture works fine.

This is the standard mapping I use for all other addons with no issues.

Any ideas?

Thanks

Glenn

[Taguilo]

Hi,

Do you have Beaver's latest version?

You can map prop lever using FS's default "Controls..." menu.

In FSUIPC you must select "Send to FS as norma axis", and then select 'Axis Propeller1 Set" in the first combo.

Tom

[GlennH]

Ok, will try that. Right now my FUSIPC GA setup sends all axis to FSUIPC for calibration.

Sounds like I need to use a new specific profile for the Beaver........

[cavaricooper]

If there is capacity, please consider allowing it to work with Throttle & Prop as well as Throttle 1 & Prop 1. I know of at least one other well known GA developer that requires Throttle (and specifically NOT Throttle 1).

Ta!

Carl

[Taguilo]

If there is capacity, please consider allowing it to work with Throttle & Prop as well as Throttle 1 & Prop 1. I know of at least one other well known GA developer that requires Throttle (and specifically NOT Throttle 1).

Ta!

Carl

Throttle control is default, no custom coded.
Beaver's latest version already has axis propeller and axis propeller1 events captured so any of these can be used to control the lever.

Tom

[cavaricooper]

Ta Tom- appreciated!

Carl