Blackbird Sims / Milviz Forum Archive

Hello Chaps,

So after thinking that I had not installed the latest version of the Beaver due to "static shaking" I had uninstalled my Beaver and installed the latest install.....after all I did have the latest installed!?! Soooo confusing!?!

So now I am thinking everything is okay but now I am finding that my Beaver keeps crashing the sim!?!

I have again uninstalled it and tried various other aircraft at the same place that I found this issue and no crashes.

I install the beaver once again and BANG! Keeps crashing.

Please help!?

Cheers,
Tim.

All I can suggest is a total uninstall again using the installer and then, as per the instructions, manually delete the relevant folders from your simobjects before reinstalling.

sunjunkiesi wrote:All I can suggest is a total uninstall again using the installer and then, as per the instructions, manually delete the relevant folders from your simobjects before reinstalling.

Thank you very much but I have done "as per the instructions" many times!! As for "manually delete the relevant folders from your simobjects before reinstalling" there are NO Beaver folders left -after the uninstall procedure- to delete!!!

Trust me I have looked!!! Unless there are some other folders somewhere that the un-installer does not pick up? After three updates this the only one I have had issues with!?!

Okay....after a little experimenting, my hypothesis is that maybe ORBX YBUD Parking 3 (RAMP GA LARGE) is the issue....?

Could someone please test for me?

The Beaver seems fine at other places. However, I keep getting crashes when I load the Beaver at this position at ORBX YBUD!?

So far.....

Cheers,
Tim.

Crashing the sim as in CTD or the aircraft crashes like in contact with the ground too fast?

Best CJ

Chuck Jodry wrote:Crashing the sim as in CTD or the aircraft crashes like in contact with the ground too fast?

Best CJ

Sorry I should have been clearer....yes a CTD. I have "Crashes" turned off in my sim.