Page 1 of 1
Inside-out Spot View
Posted: Thu Jun 01, 2017 12:03 pm
by Airtrooper
When in Spot view many of the surface normals appear to be inside out and some items (note the passengers) are incorrectly located. This is in P3D v3.4.
This was a brand new install. The only changes I made are to 2-bladed prop with spinner. Everything else is as-installed.
Andy
Re: Inside-out Spot View
Posted: Thu Jun 01, 2017 2:31 pm
by alehead
For support, you will have to register your purchase with milviz. Instructions are on the forum elsewhere or on the website...
The passengers and cargo models are stored in that location when not visible, like the heidi in accusim A2A planes...
A
Re: Inside-out Spot View
Posted: Fri Jun 02, 2017 11:41 am
by Airtrooper
Checked GPU drivers are up to date. Switched off antivirus, re-downloaded, uninstalled, re-installed, switched on antivirus. Same result! Really stuck now!
Re: Inside-out Spot View
Posted: Fri Jun 02, 2017 11:56 am
by Airtrooper
Actually, scratch that, I'm getting the same issue with some other aircraft, so it must be a sim or GPU issue... off to find out what it could be!
Many thanks