Activating Gear Control Causes Engine Cutoff

[Eagle Spirit]

While in my Milviz Beaver, water takeoff. As I clear the water I activate gear control lever (Saitek / Spad.next)) to raise, at that moment the engine cuts off. As a result, I need to execute a midair engine restart. I'll be checking my key bindings today. Anyone experiencing this issue or have any suggestions?

Regards, Eagle

[N4GIX]

Why are you using the gear control? Floats don't retract...

[doodlebug]

Water rudder?

[Eagle Spirit]

AMPHIBIANS have wheel on front of floats! (+ water rudder) Common knowledge

I'm surprised at your reply.

Eagle

[N4GIX]

AMPHIBIANS have wheel on front of floats! (+ water rudder) Common knowledge

I'm surprised at your reply.

Eagle

I don't have the Beaver installed on my development sim computer, so I didn't know if they were straight floats, or amphibious floats. Not all floats have ground gear...

So, given that why were your wheels down when you took off from the water? The gear should have been stowed while on water. Normally one doesn't extend the wheels while in water unless they are going to climb a ramp to move their aircraft to operate on land.

[Eagle Spirit]

Agree! However, I've not heard of an issue where raising the gear cuts off the engine.

Eagle

[N4GIX]

Agree! However, I've not heard of an issue where raising the gear cuts off the engine.

Neither have I for that matter. However I've never taken the time to install the aircraft. No time for me to 'play' as I'm far too busy working on projects.

[Chuck Jodry]

Does it do it if you use the keyboard? , I suspect duplicated bindings or some error of this sort , I have not seen this happen myself .

Best CJ