Blackbird Sims / Milviz Forum Archive

Posted: **Thu May 30, 2019 4:57 pm**

Greetings
Have tried several methods to configure prop RPM with my VirtulflyTq3 and will not bind with the Dhc-2 it is showing normal function and travel in FSUIPC 5 and the Prop RPm will function no problem with other aircraft, just seems to be an issue with the Beaver...

Murray

Posted: **Thu May 30, 2019 7:15 pm**

This was the fix for ProFlight, so maybe try this?

"If You use FSUPIC set up prop Axis like here (so no Prop 1 but Props)"

https://milviz.com/forum/viewtopic.php?f=137&t=8765

Posted: **Thu May 30, 2019 9:06 pm**

No that did not fix the issue, it is like the axis is not being read

Posted: **Fri May 31, 2019 10:38 am**

Post your FSUIPC profile please.

Posted: **Fri May 31, 2019 6:33 pm**

Jonathan

I fixed the issue as per above-recommended fix, I had the prop in FSUPIC still enabled as a single prop in joystick settings. The axis travel in prop pitch bind in Axis settings fixed the issue.

Murray

Blackbird Sims / Milviz Forum Archive

Propeller RPM not able to map with firtulfly Tq3

Propeller RPM not able to map with firtulfly Tq3

Re: Propeller RPM not able to map with firtulfly Tq3

Re: Propeller RPM not able to map with Virtulfly Tq3

Re: Propeller RPM not able to map with firtulfly Tq3

Re: Propeller RPM not able to map with Virtulfly Tq3