Blackbird Sims / Milviz Forum Archive

FSX Steam, Nvidia 1080ti, windows 10

The autopilot will not engage the NAV mod when using the default Radio .. or the F1 GTN 750 ( Complete ) autopilot in the MIlviz DHC 22 Beaver. All other mods work. I have uninstalled and reinstalled the latest version of the Beaver.
I set up a direct -to flight plan. Something is definitely not correct with the autopilot because when I select GPS the display blinks back and forth quickly/continuously between ROL and NAV.

When clicking on the NAV button, the display engages Nav for 1 sec and then goes back to ROL and the blinking starts again. When selecting VLOC the blinking stops.
I have the latest versions of F1 config 2.10 and GTN Complete and the Garmin trainer.
The autopilot problem is present when using the GTN 750/650 as well as the default radio.
Before I updated to the newer F1 software the autopilot NAV mod worked as it should.

Any ideas would be appreciated.

Jack

Hi Jack,

First, this isn’t the support forum. You’ll need to be in there for this.

Second, sounds like a fault with the newer F1 units.

Sorry but confused... I thought I was in the support forum for DHC-2 Beaver
Top of page showing:
Home< Board index<Milviz Specific Forums < Support Forums< DHC-2 Beaver Support Forum.

Please clarify

Thanks

You are now. The post was moved.

OK ..thanks

" sounds like a fault with the newer F1 units."..Yes and I am interested in returning to the older F1GTNconfig 2.09 but I can not locate it any where. I have posted in the F1 support site for this info but no one has answered as yet.