trouble with the beaver

[haga2000]

I am not new to FSX, but new to the Milvis DHC2 Beaver (have used the areasoft beaver earlier)
Have several newbie issues

1 I am unable to cold or hot start the plane, following the checklist accurately, I only hear a click when usung the starter switch, ( ctrl-E starts the plane as normal) what am I missing here.

2 when started the following gauges do not move:
cylinder temp. oil pressure oil temp, fuel flow and manifold pressure, regardsless of RPM


RPM and fuel level works

3) autopilot apperantly do not work, none of the buttuns work, there might be a trick that I have missed, the softspot for adjusting the frequency on the radio is so small that its is anoying to try to adjust that, any trick here.

[ScruffyTheMongoose]

Hi,

First, you need to be posting this in the support forums.

Second, it sounds like xmltools is not properly installed

[haga2000]

is there a support forum?

I see a support page out side the forum section,

[doodlebug]

Hi Havard,

For support inquiries, you must be a member of our support area. Send us your proof of purchase (either email confirmation or screencap) and we will add you.