Blackbird Sims / Milviz Forum Archive

Hello... I have uninstalled P3dV4.3 client and Content on a machine with windows home edition 10, Nvidia 1080ti, oculus rift and then installed P3dV4.4 client and Content.
Milviz DHC-2 with GTN 750/650 complete worked fine in P3d v4.3 in VR. I just purchased the C310 Redux and I have got it working but with some issues within the VR cockpit related to the GTN 750/650 but I will focus on the Milviz Beaver problem in this post first.
Updated the Flight GTN config to 2.07, Flight1 Update tool to 1.13 and already had version 171229 of the Milviz DHC -2 installed with P3dv4.3. Now when I try to load the Beaver the game shuts down. I don't see any posts concerning this problem. Completely lost as to what to do. I have limited knowledge in this area. I should mention that I deleted the P3d.cfg and the shaders folder.

Do you have the REX/Milviz weather radar activated in MVAM by any chance?
I had the same issue.
Apparently the weather radar is not yet compatible with p3dv4.4

No ... I disabled it in the MAMS. Just did a P3D repair with no positive result. I have not used the F1Config 2.07 either... just did the update.

Note: I just selected the default GPS in MAMS and the Beaver loaded so somehow the Flight1 750 Complete is causing a problem. ?????

Update: I just selected the Flight1 750 in the MAMS and it worked. I then selected the 650 and it worked. I then selected the Flight1 650/750 the sim crashed.

Any ideas?

Jack

Mine crashed the same way yours did with the F1. No answers that's I've run across yet.

should be resolved with the latest WX installer. I suspect the panel in question might have a rogue WX gauge entry.