DHC2 CYXPA Floats erratic Speed indicator / Gen. Behavior

[Eagle Spirit]

I just installed a new high end system and installed your "Beaver", which I previously have enjoyed flying, into P3D v4.1.However, in early flying, the Beaver speed indicator fluctuates wildly, 0 to over speed (gauge only). I flew the tundra version today, and it seemed better in flight.

Whats up?

Eagle

[Krazycolin]

Hi... we've not tested anything in really in 4.1 but that said, we're aware that LM has made some changes... we will investigate. But, please, don't expect an answer right away.

Thanks.

[Eagle Spirit]

TYVM!

Eagle

[Krazycolin]

Also, please post this type of thing in the support forums. That's what they're there for...

Thanks

[Taguilo]

I just installed a new high end system and installed your "Beaver", which I previously have enjoyed flying, into P3D v4.1.However, in early flying, the Beaver speed indicator fluctuates wildly, 0 to over speed (gauge only). I flew the tundra version today, and it seemed better in flight.

Whats up?

Eagle

Please remove the pitot covers before rolling on the ground (as that can't be done with the aircraft in motion).

Tom

[sunjunkiesi]

I'd also suspect icing. Were you operating in low temperatures and damp conditions?