Page 1 of 1
DHC-2 GTN 750 Integration
Posted: Fri Jun 02, 2017 4:59 am
by davidpf051
Dear Milviz,
Just picked up the DHC-2. Very nice. However, while I installed the Flight 1 GTN 750 with your MVAMS, the GTN 750 will not turn on. Tried cycling radio power and alternator. No luck. Any thoughts?
Dave
Re: DHC-2 GTN 750 Integration
Posted: Sat Jun 03, 2017 4:37 pm
by Eagle Spirit
Did you get the Garmin Light Trainer installed? I had similar issue in cockpit. 750 wouldn't turn on. Was prompted to provide "path" as trainer wasn't located / found.
Eagle
Re: DHC-2 GTN 750 Integration
Posted: Sat Jun 03, 2017 8:59 pm
by davidpf051
Yes. GTN 750 works fine with my other aircraft in P3Dv3.4. Just stays black screen with the DHC-2.
Re: DHC-2 GTN 750 Integration
Posted: Fri Jun 23, 2017 12:43 pm
by Aussie157
Are you using the correct panel for the GTN750?
Your aircraft cfg should look like this for the aircraft you are using:
[fltsim.0]
title=DHC2 Beaver CUXPA
sim=MilvizDHC2_Base
model=
panel=GTN750
sound=
texture=CUXPA
atc_id=CUXPA
atc_airline=
atc_flight_number=123
ui_manufacturer="De Havilland Canada"
ui_type="Beaver DHC2"
ui_variation="CUXPA"
ui_typerole="Single Engine Prop"
ui_createdby="MilViz DHC2 Beaver"
description="."