Recognition light switch doesn't do anything ...

[robains]

In P3D V3.4x ... I notice the recognition event is being fired (using GIT to monitor) but there doesn't appear to be any corresponding light on the aircraft that goes on/off with the switch action?

FYI on a side note, I've got most of the events/lvars mapped to my GoFlight modules via Steve's GIT (GoFlight Interface Tool), even the WX Radar ... I'll make those Exports files available later for those interested that have GF gear.

Cheers, Rob.

[N4GIX]

There is no recog light installed on this aircraft, hence the switch is only physically present but not "wired" to a non-existent light. It is only animated because... realism!