Blackbird Sims / Milviz Forum Archive

Did I miss the key command list in the manual? I have found no listing for anything except for the Force Trim assignment. I haven't found controls that respond to the normal assignments thru FSUIPC offsets:

MASTER BATTERY
STARTER
IDLE LOCK
LIGHTS (Any)

I have built my own Bell 206 cockpit, including a collective that I created on a 3D printer, that I used with the Dodosim Bell 206. Unfortunately, the Dodosim stuff will not work in P3Dv4, so that's why I went with the Milviz UH-1. Now I find that the only hardware assignments I can make in my cockpit is ailerons/elevators/rudder/collective. I haven't found the throttle, or about anything else.

Unfortunately, the Huey doesn't respond to external key commands except Force Trim. It's possible to add that feature, but it isn't present now. The AMS for instance only supports assigning that one key.

Is this all done with LVAR's then?

For the most part, yes. We do a lot of custom work and that’s the reason.

Thanks... I'm digging out some of the ones I need now using SPADnext data monitoring.