Page 1 of 1
gears not go up after takeoff
Posted: Wed Jul 13, 2016 9:15 pm
by lasko
Good evening everyone
I have just to buy the F100D, after installation, and respecting the procedures of milviz,
the gears do not fall go up after take off?
A note ( the stalk of the gears in the cockpit responds well following the command up or down) but not in external view.
Need Advice.
Is my configuration:
8 screens
Win7 64-bit
graphics card R9
RAM 12GB
Re: gears not go up after takeoff
Posted: Wed Jul 13, 2016 11:02 pm
by Kat
Dear Erich,
You forgot to mention that you are running FSX Gold, possibly without Acceleration.
This may or may not have a bearing on your problem, but it is best to let the team know.
Good luck - Kat
Re: gears not go up after takeoff
Posted: Thu Jul 14, 2016 1:23 am
by Krazycolin
Acceleration is required.
Re: gears not go up after takeoff
Posted: Thu Jul 14, 2016 10:20 pm
by lasko
Kat wrote:Dear Erich,
You forgot to mention that you are running FSX Gold, possibly without Acceleration.
This may or may not have a bearing on your problem, but it is best to let the team know.
Good luck - Kat
Good evening Kat
I use the DVD version FSX Gold therefore sp1-sp2 .
For information:
it is the same problem as with the aircraft milviz P38 Redbull!
And not with the other aircraft, and I have a 50 purchased?
best regards
erich
Re: gears not go up after takeoff
Posted: Fri Jul 15, 2016 2:10 am
by Krazycolin
Acceleration is required for most MV products, these included...
Re: gears not go up after takeoff
Posted: Sun Jul 17, 2016 9:28 am
by lasko
Krazycolin wrote:Acceleration is required for most MV products, these included...
Hi krazycollin
for information:
FSX Gold Edition of in it includes FSX deluxe and its extension acceleration!
Therefore I believe that the problem gears not return image view outside is elsewhere.
Thank you when even of intelligence.
bests regards
lasko