Wire cutters fail to display
-
christopherbritton
- Posts: 10
- Joined: Wed Dec 17, 2014 11:37 pm
- Location: United States
- Contact:
Wire cutters fail to display
Hello.
I enabled wire cutters on the bird I normally fly and just happened to notice that they don't show up on the model. I'm not sure if that's the only model part that doesn't show up, but it's the only one I have noticed so far. I'm using the latest version of the MD530F on P3Dv4.
-Chris
I enabled wire cutters on the bird I normally fly and just happened to notice that they don't show up on the model. I'm not sure if that's the only model part that doesn't show up, but it's the only one I have noticed so far. I'm using the latest version of the MD530F on P3Dv4.
-Chris
-
JonathanBleeker
- Posts: 3446
- Joined: Sat Mar 13, 2010 7:38 pm
Re: Wire cutters fail to display
Does the setting persist in the AMS?
-
christopherbritton
- Posts: 10
- Joined: Wed Dec 17, 2014 11:37 pm
- Location: United States
- Contact:
Re: Wire cutters fail to display
It does stay checked in AMS.
Last edited by christopherbritton on Tue Apr 03, 2018 12:26 am, edited 1 time in total.
-
JonathanBleeker
- Posts: 3446
- Joined: Sat Mar 13, 2010 7:38 pm
Re: Wire cutters fail to display
Your P3D is set to run as admin? (Right click on it, select properties->Compatibility->Run this program as administrator)
-
Chuck Jodry
- Posts: 442
- Joined: Mon Dec 20, 2010 4:30 pm
Re: Wire cutters fail to display
Its a glitch with the v4 versions control dll on that specific item , we will need to get it rectified .
Thank You for the report .
Best CJ
Thank You for the report .
Best CJ
-
dankel214
- Posts: 4
- Joined: Wed Apr 08, 2015 1:19 am
Re: Wire cutters fail to display
When? it's been known for a long time! I know you got your money so who cares 
