Cyclic assignmet.

[Ron Attwood]

In itself not a problem, it's the throttle. I use the Thrustmaster Warthog joystick and throttle and assigning the throttle is OK except there is no way I can reverse the axis. So the cyclic is going up when the HW throttle is going down! FSUIPC wont reverse it and neither will P3Dv4.2s controller settings have any effect. Therefore, has anyone else have or had this issue and if the sorted it out, how?
Having said all that it could well be a P3D problem. I've posted on FSUIPCs forum, I'll now trot off the Prepar3D.

EDIT: It's not a P3D thing.

[Krazycolin]

Hi Ron,

Sorry that you’re having issues (again).

While it may not be a P3D problem, we can’t help you with this because, yup, we don’t test with all of the possible3rd party devices available.

We will see if this happens with a regular throttle etc but, that’s about as far as we can go

[Ron Attwood]

Remember the Beaver and I think it was prop1 issues? Same for the 530, only Thottle1_set is the answer. Apparently, according to Pete Dowson Throttle_set is an old FS9 thing. So all sorted. Now to recover my old helicopter skillz.