New MD530 PBR, mvams not saving state and lighting issues
Posted: Tue Feb 18, 2020 8:54 am
Hi,
I got the new and improved MD530F and notice some stuff:
1. mvams settings don't all seem to take over. For instance selected radio/gps and wirecutters.
On the other hand, c&d vs ready to fly does work, as do night sun, flir pod and pontoon.
2. Lighting interior doesnt work. Not the overhead and not the gauge backlights using the turn know on the dash.
Exterior lights seem to be fine.
When looking at the ..\\appdata\local\mvams\configurations\md530 folder, I notice the files per repaint seem to be saved per my save command in mvams, with all files showing a datestamp and timestamp supporting this. However, I'm also shown "jibberish" mlvz files in the folder dated earlier.
I don't know if this has anything to do with the issues above, just thought I'd mention it.
Can you assist?
I got the new and improved MD530F and notice some stuff:
1. mvams settings don't all seem to take over. For instance selected radio/gps and wirecutters.
On the other hand, c&d vs ready to fly does work, as do night sun, flir pod and pontoon.
2. Lighting interior doesnt work. Not the overhead and not the gauge backlights using the turn know on the dash.
Exterior lights seem to be fine.
When looking at the ..\\appdata\local\mvams\configurations\md530 folder, I notice the files per repaint seem to be saved per my save command in mvams, with all files showing a datestamp and timestamp supporting this. However, I'm also shown "jibberish" mlvz files in the folder dated earlier.
I don't know if this has anything to do with the issues above, just thought I'd mention it.
Can you assist?