King Air alpha release
Posted: Fri Sep 07, 2018 5:39 pm
MV King Air 350i 180906 ALPHA
Thank you for your patience. It has been a long development and many man-hours since the first release. Although there are still a few elements left to implement, we feel it is sufficiently advanced to offer you a work-in-progress alpha build. Install at your own risk!
Important: This alpha is for Prepar3d v4.3 only. Once development is finished the released installer will support FSX:Steam as well as P3D v4.*
Remaining Items:
Proline 21:
-Airframe icing effects
-WX Radar - Integration with WX Advantage and Active Sky
-FMS data/menu control for Proline 21
-Proline 21 composite mode
-AP mode annunciation
-Half bank system
-Navigraph data integration
-Airports, NDBs, etc. display
-PLAN mode
-TAWS+ functionality missing
-Review/finish format, TCAS, TERR, WX, LX, checklist/ IFIS
ESIS:
-Airspeed and alt tape (sides)
-menu
-Barometric Setting
-Glide scope indicator
-Control knob
-Heading info
-Nav info
-Power up simulation
-Failures/warnings
General:
-AMS page
-Needs some tweaking. On a flaps up take-off there is still too much delay between rotate and vlof. With full aft elevator it is still not wanting the depart the runway until 120 KIAS.
Model:
-Fix AP knob animations
-Add VC vibrations/buffeting system
-Fix night lighting font issue
-Fix certain controls not working in the on position
-Clocks on the Yoke are inoperative
-Fix shiny tires
-Condition Levers - When grossing the latches at low idle should separate apart apprx 1 to 2 cm
-O2 handles incorrectly colored
FMS:
-Finish TEMP COMP
-IRS CONTROL
-VOR/DME CONTROL
-Finish DIR TO functionality
-DEFINED WPT/PILOT WPT
-FPLN HOLD
-PILOT ROUTE LIST
-SEARCH
-DESC INFO
-ARRIVAL data
-ATC HOLD LIST
-SEC FPLN
-MARK POINTS
-Display ADV functionality
-LNAV
-VNAV
-Improvements to leg sequencing and behavior
-Allow POS set via airport
-Performance predictions
-Refine navigation source system
-Implement mathematical and performance dependent functions
RTU:
-COM Frequency rounding cutoff
-Capture ATC ID for transponder page
-Warnings
-ADF page nav data implementation
Systems:
-Autopilot system
-Landing gear emergency operations
-Implement proper GNSS and IRS control
-Compass turn during alignment
-Icing simulation and control
-Panel state saving system
-Implement proper FMS and GPS power system
-Add final brightness
-High/Hot engine performance
-Various exterior lighting missing
-ESIS - ON w/o BAT should cause amber light to come on
-ELT - On does not cause light to illuminate
-CVR TEST/ERASE functionality missing
-BUS sense causes Warning and Caution / Advisory Panel to dim too much
Thank you for your patience. It has been a long development and many man-hours since the first release. Although there are still a few elements left to implement, we feel it is sufficiently advanced to offer you a work-in-progress alpha build. Install at your own risk!
Important: This alpha is for Prepar3d v4.3 only. Once development is finished the released installer will support FSX:Steam as well as P3D v4.*
Remaining Items:
Proline 21:
-Airframe icing effects
-WX Radar - Integration with WX Advantage and Active Sky
-FMS data/menu control for Proline 21
-Proline 21 composite mode
-AP mode annunciation
-Half bank system
-Navigraph data integration
-Airports, NDBs, etc. display
-PLAN mode
-TAWS+ functionality missing
-Review/finish format, TCAS, TERR, WX, LX, checklist/ IFIS
ESIS:
-Airspeed and alt tape (sides)
-menu
-Barometric Setting
-Glide scope indicator
-Control knob
-Heading info
-Nav info
-Power up simulation
-Failures/warnings
General:
-AMS page
-Needs some tweaking. On a flaps up take-off there is still too much delay between rotate and vlof. With full aft elevator it is still not wanting the depart the runway until 120 KIAS.
Model:
-Fix AP knob animations
-Add VC vibrations/buffeting system
-Fix night lighting font issue
-Fix certain controls not working in the on position
-Clocks on the Yoke are inoperative
-Fix shiny tires
-Condition Levers - When grossing the latches at low idle should separate apart apprx 1 to 2 cm
-O2 handles incorrectly colored
FMS:
-Finish TEMP COMP
-IRS CONTROL
-VOR/DME CONTROL
-Finish DIR TO functionality
-DEFINED WPT/PILOT WPT
-FPLN HOLD
-PILOT ROUTE LIST
-SEARCH
-DESC INFO
-ARRIVAL data
-ATC HOLD LIST
-SEC FPLN
-MARK POINTS
-Display ADV functionality
-LNAV
-VNAV
-Improvements to leg sequencing and behavior
-Allow POS set via airport
-Performance predictions
-Refine navigation source system
-Implement mathematical and performance dependent functions
RTU:
-COM Frequency rounding cutoff
-Capture ATC ID for transponder page
-Warnings
-ADF page nav data implementation
Systems:
-Autopilot system
-Landing gear emergency operations
-Implement proper GNSS and IRS control
-Compass turn during alignment
-Icing simulation and control
-Panel state saving system
-Implement proper FMS and GPS power system
-Add final brightness
-High/Hot engine performance
-Various exterior lighting missing
-ESIS - ON w/o BAT should cause amber light to come on
-ELT - On does not cause light to illuminate
-CVR TEST/ERASE functionality missing
-BUS sense causes Warning and Caution / Advisory Panel to dim too much