Sound Loops (switch or oxygen)

[msm607]

Hi everyone. Has anyone had an issue with "looping" sounds? I'm not sure when this problem started, but when I load up the KA (per the instructions I've read on the forum and other ways by experiment), I get a constant looping sound of either the oxygen levers being pulled, the oxygen mask test noise, or a switch looping sound. I can't rule out that it's a problem with my particular system and not the KA's fault, but I thought I'd ask you all. I only experience it with the KA, not the Baron or C310.

Does or have any of you experienced this? If so, how did you get it to stop?

I'm running P3dv4.

Thanks,

Scott

[sharpless281]

I just tried it now and I did not hear anything looking. I do hear the oxygen tank lever make a sound but it is not looping. I need to see how to do a oxygen mask test to try that next. BTW do you like the C310, thinking about getting it and see if I can port it to P3D 5. (its worth the risk if it does not work)

[Slayer]

If you are experiencing odd behavior sometimes a sim restart will fix it, especially if you are using other aircraft prior.

[msm607]

Thanks, for your reply Steve. I understand that it's probably hard to duplicate on your end.

A restart doesn't seem to fix the issue, and it's really strange that it only happens with the lower resolution textures installed, but if I uninstall and reinstall with the HD textures, the issue goes away. It may just be my computer; perhaps maybe the next update version will fix it.

[msm607]

@sharpless

Yes, I think the 310 is absolutely worth a purchase. I have put a lot of hours on it and think it stands up well over time and against A2A planes, which I also fly extensively. The ability to have both the GTN and radar on the panel at the same time is one of the main reasons I enjoy it so much. I feel the same way about the Baron, which I flew for a few hours last night between Little Rock and Destin, Fl.

[sharpless281]

Ok cool, I might give it a try

[Slayer]

Keep in Mind I don't believe the 310 is updated for V5 yet. I don't have an ETA.