Propeller and / or Condition axis gone twitchy overnight
Posted: Mon Apr 19, 2021 1:05 am
Was flying last night all was fine. Started up today and noticed pitch axis twitching full on full off about once every second or so. Saw also that it was only one side of two (L/R), the left side. Restarted sim, reloaded aircraft now pitch axis is fine, but now condition levers are flapping full on / off about once every second. Again only one side, this time the right
It is not my controller as:
* I checked all calibration, and;
* Both are mapped to single axis controls
This means the propeller axis can only move Both Pitch sides and the Conditioner axis Both Condition sides at a time, not individual sides which this is exhibiting. Also loading up my trusty Real Air Turbo Duke which uses identical mappings and hardware everything works as expected with no flapping. (Saitek X52)
I did open the controller page today in MVMS, but I set nothing and everything reports unmapped.
Looking for suggestions as I feel the issue is in the KA 350 , not my hardware.
Thanks in advance,
-btacon
It is not my controller as:
* I checked all calibration, and;
* Both are mapped to single axis controls
This means the propeller axis can only move Both Pitch sides and the Conditioner axis Both Condition sides at a time, not individual sides which this is exhibiting. Also loading up my trusty Real Air Turbo Duke which uses identical mappings and hardware everything works as expected with no flapping. (Saitek X52)
I did open the controller page today in MVMS, but I set nothing and everything reports unmapped.
Looking for suggestions as I feel the issue is in the KA 350 , not my hardware.
Thanks in advance,
-btacon