Axis Calibration in Milviz addon
-
sharpless281
- Posts: 123
- Joined: Tue Feb 16, 2021 1:21 am
Axis Calibration in Milviz addon
I am trying to figure out the calibration of my 2 throttles. in KVMAS, I move the throttle all the way back for Max Rev. Move to Idle and set that. Then move all the way forward and set Max power. I do not know what the beta is for so I ignore it. So this is saved now. In FSUIPC 6, I set the throttle axis but what do I use for Calibration since the KVMAS is doing this. Do I just set the axis in P3D?
-
Slayer
- Posts: 1517
- Joined: Sat Mar 08, 2014 3:26 am
- Contact:
Re: Axis Calibration in Milviz addon
I've moved this post to the KA support section since you are a registered user. At the top of the posts there are stickied topics regarding what you are trying to do.
The basic idea:
Set up your throttles axis either via P3D or FSUIPC not both. If you do use FSUIPC then do NOT calibrate the axis in that program or it will not work.
The MVAMS calibration ONLY calibrates the position of the throttle related to what relative position the axis is at for the range. It is not a calibration routine for your axis itself.
To keep it simple think of BETA as kind of a neutral position, so you aren't moving forward or in reverse.
The most reliable way is setup the axis via P3D and set your throttle ranges in MVAMS.
The basic idea:
Set up your throttles axis either via P3D or FSUIPC not both. If you do use FSUIPC then do NOT calibrate the axis in that program or it will not work.
The MVAMS calibration ONLY calibrates the position of the throttle related to what relative position the axis is at for the range. It is not a calibration routine for your axis itself.
To keep it simple think of BETA as kind of a neutral position, so you aren't moving forward or in reverse.
The most reliable way is setup the axis via P3D and set your throttle ranges in MVAMS.