Page 1 of 1
Enable Text Window on the CDU [Answered]
Posted: Thu Sep 24, 2020 12:55 pm
by maenixon
Hi,
I've finally managed to get the KA350i to take off and follow a Flight Plan.
Now I see a message on the MFD: "Enable Text Window on the CDU".
How do I do this? I assume it's done on the FMS/CDU but I cannot see how...
Re: Enable Text Window on the CDU
Posted: Fri Sep 25, 2020 12:28 am
by Taguilo
Hi,
in CDU press MFD Menu key, then LSK 6 Left (Window) until it shows ON or VNAV
Tomas
Re: Enable Text Window on the CDU
Posted: Fri Sep 25, 2020 1:12 am
by maenixon
Hi Taguilo,
You say "in CDU press MFD Menu key, then LSK 6 Left (Window) until it shows ON or VNAV".
But when I do that, all I get is GNSS Status, not ON or VNAV.
The last time I did that and pressed EXEC, i crashed my flight!
What gives?
Re: Enable Text Window on the CDU
Posted: Fri Sep 25, 2020 1:13 pm
by maenixon
Hi again Taguilo,
I tried pressing MFD Menu/LSK 6 and found OFF/ON/VNAV but nothing happened and the message on the MFD is still there.
What do I do next? Pressing EXEC does nothing.
Re: Enable Text Window on the CDU
Posted: Fri Sep 25, 2020 2:22 pm
by Taguilo
Ok,
Press FORMAT lsk in Left PFD until ROSE mode is in view.
Now repeat the previously described steps.
Tomas