Reset Initial Pos[Resolved]

[mbnicholson]

Yesterday, I signed into the forum to ask about a few problems with the FMS I was having in the Beta 1.1.37 Beta. I saw the new 1.1.38 Beta and hoped it might solve some of my questions. Although I just hated to uninstall and reinstall the 350i again, I did. I can just about do it in my sleep now. So, two of my problems were repaired. I still need help with when setting up the FLPN and entering the Pos Init with the GNSS, it enters the correct location; however, I receive the Msg: Reset Initial Pos. The rest of my FMS setup went fine And I was able to complete my IFR cross country. I have read where I should be able to delete the Message, or at least not show it for the whole flight. I wish it would just stay in the message center. It appears it prevents any further messages by blocking them. I have read how I should be able to delete these; however, I just haven't had any luck in doing it. Appreciate any advice.

Mike Nicholson, Jetline Systems PC, 4.20 Intel 4 Core i7-7700k CDU, Nividia GTX 1060 6GB card, 32722 mbs memory, Windows 10- 64bit, Prepar3D v4.5 Pro

[ccmh15]

Check this out:

viewtopic.php?f=105&t=11540&p=95260&hil ... nit#p95260

Cheers,
Chris

[Slayer]

Thanks Chris

[mbnicholson]

A couple of days ago, on the Pos Init page, I as always clicked on the GNSS coordinates to copy, and inserted them into the Initial Pos circle. The initial waypoint was 18 nm outbound. I got the Reset Initial Pos message again. So, I sat there looking at it, and decided to just do what it asked. I clicked on the GNSS cooridinates to copy, and and clicked on the Initial Pos circle. Message vanished . Worked again this am. Appreciate the answers, Mike Nicholson