Left prop lever will not go to high rpm (stops halfway)
Posted: Mon Jun 22, 2020 1:47 am
I followed the guide for setting up my throttles through FSUIPC and got most things working except one of my prop levers. My left prop stops halfway and will not go to max rpm. If I move the throttles to max rpm together, it briefly goes to max before snapping back to 50%. Below is my axis.cfg so maybe there is something there that is preventing it. I am unsure how to delete previous assignments so I am not sure if the [prop] section is still active. I originally had it setup on one axis but later decided to switch to separate axis's. I uploaded a short clip showing the issue.
https://youtu.be/Yta5Cc03eJ0
[GENERAL]
enabled=1
[THROTTLE]
reverse=-16383
beta=-12451
idle=-9830
max=16383
invert=1
[THROTTLE1]
reverse=-16383
beta=-12451
idle=-9830
max=16383
invert=1
[THROTTLE2]
reverse=-16383
beta=-12451
idle=-9830
max=16383
invert=1
[PROP]
feather=-16383
min=256
max=16383
invert=1
[PROP1]
feather=-16383
min=256
max=16383
invert=1
[PROP2]
feather=-16383
min=256
max=16383
invert=1
[CONDITION]
off=-16383
lowidle=-4587
highidle=16383
invert=1
[CONDITION1]
off=-16383
lowidle=-4587
highidle=16383
invert=1
[CONDITION2]
off=-16383
lowidle=-4587
highidle=16383
invert=1
https://youtu.be/Yta5Cc03eJ0
[GENERAL]
enabled=1
[THROTTLE]
reverse=-16383
beta=-12451
idle=-9830
max=16383
invert=1
[THROTTLE1]
reverse=-16383
beta=-12451
idle=-9830
max=16383
invert=1
[THROTTLE2]
reverse=-16383
beta=-12451
idle=-9830
max=16383
invert=1
[PROP]
feather=-16383
min=256
max=16383
invert=1
[PROP1]
feather=-16383
min=256
max=16383
invert=1
[PROP2]
feather=-16383
min=256
max=16383
invert=1
[CONDITION]
off=-16383
lowidle=-4587
highidle=16383
invert=1
[CONDITION1]
off=-16383
lowidle=-4587
highidle=16383
invert=1
[CONDITION2]
off=-16383
lowidle=-4587
highidle=16383
invert=1