Page 1 of 1
Fuel Load Reset to 100% All Tanks [resolved]
Posted: Sun Jun 07, 2020 4:50 am
by norcali.pilot
When I change the fuel load using the in-sim fuel/payload manager, the changes are not saved and all fuel tanks go to 100% after I press 'OK'.
Immediately after I make the changes I verify the fuel quantities I see the needle trending down before bounding back up a moment later.
P3D v4.5H2(or H3 whichever one is most recent)
KA 1.1.29
Re: Fuel Load Reset to 100% All Tanks
Posted: Sun Jun 07, 2020 10:52 am
by Bushido
Did you Check you are not parked near a fuel pump ?
Try it again on the runway just to be sure.
Re: Fuel Load Reset to 100% All Tanks
Posted: Sun Jun 07, 2020 4:04 pm
by norcali.pilot
That was the issue. I didn't know fuel pumps did that and didn't notice I was next to it.
Thank you!
Re: Fuel Load Reset to 100% All Tanks
Posted: Mon Jun 08, 2020 9:15 am
by Nac301
The only places you anjust fuel is in Mvams and you have too unload Airplane from P3d too get it right
- -2020-jun-8-055.jpg (219.7 KiB) Viewed 994 times
Re: Fuel Load Reset to 100% All Tanks
Posted: Tue Jun 09, 2020 7:29 am
by ccmh15
I always use the P3D "Fuel and Payload" dialogue, even for re-fueling and change in Pax/Cargo between succeeding legs, and it's working perfectly fine.
No need to use MVAMS and/or to unload the sim!
Chris