Blackbird Sims / Milviz Forum Archive

Hello,

I am trying to get my Saitek throttle quadrants (2 quadrant's, 6 levers) to work with the King Air. I have followed the calibration document provided in the forums and calibrated both in FSUIPC and the Milviz calibration utility. The throttles only move from idle to about 10% and will not travel to full power. Any ideas?

Best Regards,

John

You must calibrate using only MVAMS
more info here:
http://www.milviz.com/forum/viewtopic.php?f=105&t=12110

What about the detent to go into reverse? On the Saitek quadrant if you pull the throttles back past the detent it works as a button and not an axis. So when I pull the throttle back to the detent MVAMS thinks the throttle is in full reverse and not beta range.

I am sorry , I do not have Saitek, but there are plenty of users on the forum who do - I am sure they will help.