Crash to Desktop upon Entering Altitude Constraint
-
- Posts: 57
- Joined: Sun Dec 22, 2019 1:27 pm
Crash to Desktop upon Entering Altitude Constraint
Hi,
as per separate post I just took the following route:
KSBA KWANG5 HENER V186 FIM V386 OKACO KL35
I had entered all waypoints until OKACO without selecting an approach to KL35. During climb I entered a altitude constraint /9400 at OKACO, still without approach selected.
Upon pressing EXEC P3D crashed to desktop without error message. Unfortunately I wasn't able to take a screenshot.
Is there any known issue or limitation I should know about before trying to reproduce the full flight?
Cheers,
Stefan
as per separate post I just took the following route:
KSBA KWANG5 HENER V186 FIM V386 OKACO KL35
I had entered all waypoints until OKACO without selecting an approach to KL35. During climb I entered a altitude constraint /9400 at OKACO, still without approach selected.
Upon pressing EXEC P3D crashed to desktop without error message. Unfortunately I wasn't able to take a screenshot.
Is there any known issue or limitation I should know about before trying to reproduce the full flight?
Cheers,
Stefan
- doodlebug
- Posts: 1642
- Joined: Sun Feb 19, 2017 2:49 pm
- Location: LYX>YUL
Re: Crash to Desktop upon Entering Altitude Constraint
What build are you using?
-
- Posts: 57
- Joined: Sun Dec 22, 2019 1:27 pm
Re: Crash to Desktop upon Entering Altitude Constraint
That was 1.1.28.
-
- Posts: 141
- Joined: Thu Mar 12, 2015 1:53 pm
- Location: United States
Re: Crash to Desktop upon Entering Altitude Constraint
I am unable to reproduce this - can you give me exact steps and what waypoint you were en route to?
-
- Posts: 57
- Joined: Sun Dec 22, 2019 1:27 pm
Re: Crash to Desktop upon Entering Altitude Constraint
Hi Colin,Turbofandude wrote: ↑Tue May 26, 2020 3:04 pmI am unable to reproduce this - can you give me exact steps and what waypoint you were en route to?
I departed Rwy 15L, manually turned in direction of KWANG, set a Direct-To KWANG, then activated autopilot with NAV and VS. Approaching KWANG I added the altitude constraint at OKACO and pressed EXEC, resulting in the CTD. This was in version 1.1.28.
I just had another CTD after entering the following route in the Flightplan page upon initializing the FMC in new version 1.1.29:
KHHR SMO V107 SADDE V299 VTU KWANG KSBA
After adding KWANG I pressed EXEC and P3D immediately crashed to desktop without error message. Upon retrying the same flight and actions it worked fine, i.e. I cannot reproduce the error.
I don't think there's a relation to the fix KWANG. It's just the most common used fix for departures/arrivals at KSBA.
That's all input I can provide for now.
Cheers,
Stefan