Engine Control Configuration
-
- Posts: 2
- Joined: Mon Dec 23, 2019 8:51 pm
Engine Control Configuration
Hello,
I am running a fresh install of 1.1.24 and am unable to operate the engine controls using my throttle quadrant. I have followed the instructions provided in the 'Engine Controls Configuration Tutorial' but, so far, have not been successful. I am assigning my controls through FSUIPC but encountered the same problem when assigning directly through P3D.
My configuration is listed in my signature.
Any advice you could provide would be hugely appreciated!
Thanks,
Steve
I am running a fresh install of 1.1.24 and am unable to operate the engine controls using my throttle quadrant. I have followed the instructions provided in the 'Engine Controls Configuration Tutorial' but, so far, have not been successful. I am assigning my controls through FSUIPC but encountered the same problem when assigning directly through P3D.
My configuration is listed in my signature.
Any advice you could provide would be hugely appreciated!
Thanks,
Steve
-
- Posts: 50
- Joined: Sat Jan 04, 2020 7:54 pm
Re: Engine Control Configuration
For some unknown reason, the recommended assignment setup doesn't work at all for me either, with either no response or wildly erratic fluctuations. I need to both calibrate through MVAMS and send to FSUIPC calibration (but I haven't calibrated the axis, just sent it there), in order to get normal function from the KA power levers. Maybe it'll work for you too. I've reinstalled the KA a lot of times, always deleting all folders in Appdata and P3D, I've tried to clean out and reinstall FSUIPC, but always the same result.
-
- Posts: 2
- Joined: Mon Dec 23, 2019 8:51 pm
Re: Engine Control Configuration
Thank you very much for the reply. I followed your instructions and was able to get the power, prop and condition levers working properly.
Best regards,
Steve
Best regards,
Steve