INVALID activation

Locked
nimsu87
Posts: 9
Joined: Mon May 04, 2020 12:07 am
INVALID activation

Post by nimsu87 » Fri May 08, 2020 8:03 pm

Hi, I purchased the KA350 a few days ago, I installed it on my PC but it was running slow as was prepar3d. I did a system wipe to see if it would work after but the gauges were not working properly, I then tried to uninstall and reset p3d making sure all virus software etc was off. I tried to install again but this time the activation was invalid. I am guessing this is piracy protection that I can understand. However I can assure you all installs have been on one PC, I can prove this if you want any logs sending. In short please could you get back to me and I'll provide all necessary info so that my key can be reactivated. Thanks.

best wishes

Nim Sandhu

User avatar
doodlebug
Posts: 1642
Joined: Sun Feb 19, 2017 2:49 pm
Location: LYX>YUL
Re: INVALID activation

Post by doodlebug » Sat May 09, 2020 1:27 am

email me and I will check your activation.
it maybe that you need to uninstall and then reinstall once more

nimsu87
Posts: 9
Joined: Mon May 04, 2020 12:07 am
Re: INVALID activation

Post by nimsu87 » Sat May 09, 2020 1:28 am

thanks a lot, I sent you a private message earlier, did you receive it?

nimsu87
Posts: 9
Joined: Mon May 04, 2020 12:07 am
Re: INVALID activation

Post by nimsu87 » Sat May 09, 2020 1:32 am

I've messaged info@miliviz with my order id and serial code too. Hope this helps!

nimsu87
Posts: 9
Joined: Mon May 04, 2020 12:07 am
Re: INVALID activation

Post by nimsu87 » Sat May 09, 2020 1:50 am

I have just redownloaded, lowering my available future downloads, I will try this but doubtful it will work

User avatar
doodlebug
Posts: 1642
Joined: Sun Feb 19, 2017 2:49 pm
Location: LYX>YUL
Re: INVALID activation

Post by doodlebug » Sat May 09, 2020 2:39 am

don't use the one in your downloads - use this one: viewtopic.php?f=105&t=12040

Nac301
Posts: 54
Joined: Tue Mar 25, 2014 6:33 am
Contact:
Re: INVALID activation

Post by Nac301 » Mon May 11, 2020 9:13 am

You can put in the registation direct in
your disk :\Prepar3D v4\Milviz
in MVKA350i.ini
Attachments
-2020-may-11-001.jpg
-2020-may-11-001.jpg (102.59 KiB) Viewed 967 times


Locked

Return to “K.A.350 Support Forum”