Page 1 of 1
Condition levers snap back to cut off when I adjust them
Posted: Sun May 03, 2020 3:48 am
by spencer.hoefer
I am having some issues with the condition levers going straight to engine cutoff when I try to adjust them during engine start. Do they need to be bound to a hotkey instead of mouse control?
Re: Condition levers snap back to cut off when I adjust them
Posted: Sun May 03, 2020 2:22 pm
by alehead
Sounds like they might be somehow bound to a joystick axis that is zeroed...
A
Re: Condition levers snap back to cut off when I adjust them
Posted: Sun May 03, 2020 3:26 pm
by Nac301
Had that simular problem
never reload Aircraft then it happend for me
Restartet P3d and problem solved ..........
Re: Condition levers snap back to cut off when I adjust them
Posted: Sun May 03, 2020 8:47 pm
by spencer.hoefer
Thanks guys, but I haven't reloaded the aircraft. The only thing I have done is go into fuel and payload to look at my weights. The right condition lever only snaps back to cut off when I am starting my second engine (left engine).
Re: Condition levers snap back to cut off when I adjust them
Posted: Mon May 04, 2020 1:30 am
by meese91
I've seen this a couple of times, the only fix has been a sim restart.