Yoke don't move, Power leavers stuck ++
-
- Posts: 2
- Joined: Wed Apr 01, 2020 6:36 pm
Yoke don't move, Power leavers stuck ++
Hi!
I've bought the KA yesterday. Since then I've read the forum, reinnstalled, and tried the hotfix several times I also did an full reinstall of the p3D itself.
The yoke don't move in the elevator axis, but I have the input from the joystick because the elevator itself moves on the tali. Power leavers are stuck in the reverse positon. If i use the "F1-F4" someting happens, engine sound is affected, and the plane starts to yaw to the left. But it don't move forward (brakes off and no chock) Still i get an increasing airspeed, noise from the takeoff run, and i can pitch the nose up.
whats wrong?
Best regards
I've bought the KA yesterday. Since then I've read the forum, reinnstalled, and tried the hotfix several times I also did an full reinstall of the p3D itself.
The yoke don't move in the elevator axis, but I have the input from the joystick because the elevator itself moves on the tali. Power leavers are stuck in the reverse positon. If i use the "F1-F4" someting happens, engine sound is affected, and the plane starts to yaw to the left. But it don't move forward (brakes off and no chock) Still i get an increasing airspeed, noise from the takeoff run, and i can pitch the nose up.
whats wrong?
Best regards
- doodlebug
- Posts: 1642
- Joined: Sun Feb 19, 2017 2:49 pm
- Location: LYX>YUL
Re: Yoke don't move, Power leavers stuck ++
Can you please try using the MVAMS utility on your desktop to configure your controls.
-
- Posts: 2
- Joined: Wed Apr 01, 2020 6:36 pm
Re: Yoke don't move, Power leavers stuck ++
Hi! First of all thanks for quick response!
I've used the MVAMS. But it seems like the fault was indeed induced by myself. ` I've forgot one or more step in disabling the firewall and allowed files and folders. Now it installed properly.
Now its time to use MVAMS!
I've used the MVAMS. But it seems like the fault was indeed induced by myself. ` I've forgot one or more step in disabling the firewall and allowed files and folders. Now it installed properly.
Now its time to use MVAMS!