Adding Victor or Jet Airways to Flight Plan

Locked
gerryj
Posts: 21
Joined: Thu Feb 28, 2019 10:40 pm
Adding Victor or Jet Airways to Flight Plan

Post by gerryj » Wed Mar 11, 2020 8:43 am

I have been unsuccessful in adding either Victor or Jet airways into the FMS flight plan, including following the instruction video MilViz KA350i Basic flight Plan at https://youtu.be/dp2mSStAH7c step-by-step. I even went to far as to update the Navigraph data to the current AIRAC cycle but still no joy. What am I missing? I can enter the flight plan using VORs and intersections but that is much more tedious than entering the airway and just the exit point.

BTW, I absolutely love this aircraft! It is a thing of beauty and the systems depth is excellent. Night flights are a joy with fantastic interior and exterior lighting.

KenG
Posts: 157
Joined: Sat May 09, 2015 2:33 am
Re: Adding Victor or Jet Airways to Flight Plan

Post by KenG » Wed Mar 11, 2020 1:38 pm

Make sure the first waypoint entered on the right side is a point on the airway, the airway is entered immediately following on the left side, and a valid exit point is entered on the same line right side as the airway.

I have never had an issue with V and J routes but sometimes T and Q routes would not be in the system. I have not tried colored airways or route outside of North America, but we have plenty of testers from other regions whom I assume tested.

gerryj
Posts: 21
Joined: Thu Feb 28, 2019 10:40 pm
Re: Adding Victor or Jet Airways to Flight Plan

Post by gerryj » Wed Mar 11, 2020 8:57 pm

KenG wrote:
Wed Mar 11, 2020 1:38 pm
Make sure the first waypoint entered on the right side is a point on the airway, the airway is entered immediately following on the left side, and a valid exit point is entered on the same line right side as the airway.
Thank you! That was my problem. The instructional video doesn't show a cursor and I was having problems figuring out which keys he is pressing throughout the video.

All is well now, so back to flying this excellent aircraft!

Gerry

KenG
Posts: 157
Joined: Sat May 09, 2015 2:33 am
Re: Adding Victor or Jet Airways to Flight Plan

Post by KenG » Thu Mar 12, 2020 12:58 pm

Yes, sorry about the cursor issue, I did not figure out until the last video that the capture software had to be run as administrator to capture the mouse clicks properly.


Locked

Return to “K.A.350 Support Forum”