B350 F-PLAN and FMS NAV
-
- Posts: 31
- Joined: Sat Dec 28, 2019 5:45 am
B350 F-PLAN and FMS NAV
I flew from Innsbruck to samdan. When actually planning, LOWI was from Runway08departure. When taxiing, the wind changed and I decided to temporarily change to Runway26 department but can't select Rwy26 in FMS.
At this time, I re-entered the form / to content and re-planned, but after taking off, FMS cannot fly according to the preset route. The "FMC" mode is displayed in FMA. If you use the DIR function to direct to the next waypoint, you cannot continue after arrival Follow the route.
At this time, I re-entered the form / to content and re-planned, but after taking off, FMS cannot fly according to the preset route. The "FMC" mode is displayed in FMA. If you use the DIR function to direct to the next waypoint, you cannot continue after arrival Follow the route.
-
- Posts: 31
- Joined: Sat Dec 28, 2019 5:45 am
Re: B350 F-PLAN and FMS NAV
update to 1.0.6 is oK
if the flight plan changed during Flight , the FMC's ACT LEGS - SEQUNACE "auto"change to 'inhibit'.
to change it to AUTO , can via the flight plan route point by point
it's very good for PL21 Simulation !
Great work !

if the flight plan changed during Flight , the FMC's ACT LEGS - SEQUNACE "auto"change to 'inhibit'.
to change it to AUTO , can via the flight plan route point by point
it's very good for PL21 Simulation !
Great work !



