Page 1 of 1
How do i program a hold?
Posted: Thu Feb 20, 2020 8:57 am
by r_ribes90
Hi,
I have tried to program the parameters on the 'HOLD' page of the FMS, but I have not managed to assign it to a fix.
Nor have I found a user guide that explains it.
Is this feature available?
Thanks!
R_Ribes90.
Re: How do i program a hold?
Posted: Thu Feb 20, 2020 2:43 pm
by matpietsch
Have you installed version 1.0.6?
Re: How do i program a hold?
Posted: Thu Feb 20, 2020 5:27 pm
by r_ribes90
matpietsch wrote: ↑Thu Feb 20, 2020 2:43 pm
Have you installed version 1.0.6?
No. Just the 1.0.1 one...
1.0.6 is a beta.
Thanks!
R_Ribes90.
Re: How do i program a hold?
Posted: Fri Feb 21, 2020 8:22 am
by matpietsch
Not more beta then the 1.0.1. Recommend installing it
Re: How do i program a hold?
Posted: Fri Feb 21, 2020 8:44 am
by r_ribes90
I have tried it and the power lever is very erratic. The plane is unmanageable.
I have returned to the previous version ...
Re: How do i program a hold?
Posted: Fri Feb 21, 2020 10:12 pm
by qqwertzde
I had exactly the same problem: after the update, the throttle quadrant was unusable and I reinstalled 1.0.1. Later, I tried again and it worked fine: right after installing 1.0.6, I went to MVAMS and calibrated the axes. Maybe that made the difference.
Peter
Re: How do i program a hold?
Posted: Sun Feb 23, 2020 8:50 pm
by r_ribes90
Tested again. After calibrating this time with MVAMS, power levers are working ok.
...but PFD & Nav displays are black (well, really they are with strange icons and buttons inserted
).
So, i better should wait until the next announced release
Thanks for your advices!
R_Ribes90.
Re: How do i program a hold?
Posted: Mon Feb 24, 2020 11:59 am
by KenG
You have to uninstall first then install. I am not sure why, but if I do not uninstall then reinstall it always messes up my installations.