Page 1 of 1
Axis assignments on MVAMS don't work
Posted: Mon Feb 03, 2020 10:43 am
by ificratis
Hi,
Using the latest HF beta 1.0.6 :
I assign all levers through MVAMS and hit Save and Save Defaults. I use the VF TQ6+ quadrant. However when I load the plane, none of the levers can move when I use my hardware levers.
Re: Axis assignments on MVAMS don't work
Posted: Mon Feb 03, 2020 5:08 pm
by JonathanBleeker
The MVAMS is NOT for assigning hardware axes to the controls. It is for calibration only. The controls must still be assigned in P3D, or FSUIPC.
Re: Axis assignments on MVAMS don't work
Posted: Tue Feb 04, 2020 8:49 am
by ificratis
JonathanBleeker wrote: ↑Mon Feb 03, 2020 5:08 pm
The MVAMS is NOT for assigning hardware axes to the controls. It is for calibration only. The controls must still be assigned in P3D, or FSUIPC.
How? The P3D controls allow only separate axis assignment for throttle and reverser/beta range. I did assigned the controls in P3D (for example throttle1) having calibrated the axes in MVAMS but moving to beta range my hardware controller would not move it in the sim. I use Virtual Fly's TQ6+. Can you explain how I can make it to work step by step?