Page 1 of 1

Erratic engine parameters with HF2

Posted: Sun Feb 02, 2020 9:33 pm
by meese91
Power axis assigned in P3D settings, and tried both with one assigned PROP axis and no prop axis assigned at all, but both calibrated through MVAMS. Both engines behaves very jittery, bouncing up and down in torque, RPM, N1 and ITT, with smooth application and visually smooth movements of the controls in the virtual cockpit. The PROP PITCH annunciators also strobes a lot on ground. See the two attached videos, the engines behaves like this regardless of weather, density altitude, etc. While jittering up and down, they also seem to start feathering a lot, but bounce back before they fully do so. I'll try a full product uninstall and file removal followed by a reinstall next. Picture of MVAMS power lever axis included, and the MVAMS crashes a lot when I'm using it for axis calibration as well.

https://streamable.com/ng168
https://streamable.com/8xick

MV axis.jpg
MV axis.jpg (29.61 KiB) Viewed 1177 times

Re: Erratic engine parameters with HF2

Posted: Mon Feb 03, 2020 11:52 am
by meese91
Full reinstall, made sure I deleted any MV-folder after uninstall in both the P3D and Appdata, restarted before and after installation, with Defender completely shut down during download, uninstall, and installation. Still have these odd fluctuations all along the power range, and even at certain static power settings it sounds and feels like the prop is jumping into feather a lot.

The new installed MVAMS still keeps crashing when accessing axis calibration.

Re: Erratic engine parameters with HF2

Posted: Tue Feb 04, 2020 3:27 pm
by meese91
Is it only me having this issue?

Re: Erratic engine parameters with HF2

Posted: Wed Feb 05, 2020 11:53 pm
by mari8it
Same happens to me whit dual axes thrust master super solid and spike free throttle , please solve cause the aircraft is unusable in this conditions , thanks

Re: Erratic engine parameters with HF2

Posted: Thu Feb 06, 2020 12:22 am
by mari8it
meese91 wrote:
Tue Feb 04, 2020 3:27 pm
Is it only me having this issue?
Hi sir , solved now for me ,cleared the P3d axes assignments then I used fsuipc to assign axes to throttles using “send to FS as normal axis” -> Axis Throttle 1 set
( for throttle 1 obviously) etc for eng 2 , this solve for me
Making this for prop also makes the axes more precise .
Hope this could help you also

P.s. don’t use fsuipc’s joystick calibration !!! This stop the axes to work

Re: Erratic engine parameters with HF2

Posted: Fri Feb 07, 2020 4:51 pm
by meese91
Thank you very much, that fixed it. I had to send them to FSUIPC, not FS, but didn't calibrate them, and that worked well.