Page 1 of 1

Avionics shutdown in climbout

Posted: Fri Jan 24, 2020 10:43 pm
by am.pharoah
Hello,

I'm doing something wrong / missing something.

After takeoff, during the climb, I suddenly loose the Avionics (PFD etc). Avionics master switch is still on.

What step am I missing that might cause this please?

For sure pilot error, but I've followed the Milviz site tutorial movies closely. Any advice please?

Thanks in anticipation

Andrew

Re: Avionics shutdown in climbout

Posted: Sat Jan 25, 2020 12:52 am
by Taguilo
Hi,

Right after each engine start reaches idle speed, remember to turn off the Starter switch and after that move side GEN switch to Reset and then release. Check that GEN amber annunciators on top of left/right annunciator panel sides are extinguised.

Tomas