Blackbird Sims / Milviz Forum Archive

Today, I purchased your B350i, downloaded and installed, Run as Admin. No AV installed!

I did a clean reinstalled, etc... with no luck!

While aircraft starts/runs OK, I have no FMS that will turn on or work, no display on screen, right seat and the flaps are not extending, etc...? I had one CTD while aircraft was running!

I did an updated with Navigraph FMS Manager!

Most other systems are OK!

Sorry for the trouble!

Thank you!

GLM

PC Win. 10 64. P3D v4.5

After engine start is completed, you need to engage its respective generator - switches are located in the small box, together with Battery switch (Left), Left Generator (Middle) and Right Generator (Right). Move them momentarily in up position (they will return to middle position).
Observe lower annunciation panel (one behind power/prop levers) - in left/right top corner, you have amber warnings illuminated that means that generators are not active.
FMS and Right screen are powered from dedicated electric bus, not directly from battery. Other options to power these component is to use GPU unit (best) - you can find this option in Add-ons menu, or (not recommended IRL) to use Gen-Ties switch to manually close battery circuit with other buses in this aircraft.

OK! Many thanks!

I will give that ago, will notify the results!

Also I will recheck the flaps!

GLM

Got It! Thanks!

Flaps OK!

Quick question. How do you change from LBS to KGS, Fuel, etc...?

I'm sorry, reconfiguration of PL21 to metric units is an option available for service personnel. So you will not find it in FMS or on any of the screens.
Here in sim, the only option I see would be to have such option in MVAMS. Perhaps this could be added as a roadmap item. This is question for the Milviz team.

OK, thanks!

I will have to do the conversion Kgs to Lbs at planing, fuel!

Maybe something that can done in the future, updates, etc... to MVAMS.

Please pass it on to the team and many thanks.

Best wishes.

GLM