Page 1 of 1

Power Lever ranges

Posted: Thu Jan 09, 2020 8:59 pm
by johnh
Hi All,
My Saitek throttles only work from 64% to 100% and the -25 hack didn't work for me. Not really a major but can anyone tell me at what percentage the throttles change from Ground Fine to Reverse? Or even what the settings are for the two "Lift" spots?

And Yes I know this will all be fixed in the upcoming SP but I would like to get taxiing in the meantime

Re: Power Lever ranges

Posted: Fri Jan 10, 2020 1:47 am
by meese91
My full axis range goes from flight idle to firewall, while beta and reverse both on the reverse axis, meaning you can't fine adjust taxi AND have in flight power lever command on the same axis. I don't know if FSUIPC lets you combine two different axis or toggle two axis on one physical axis.

Personally I much prefer to have reverse stops to firewall on my axis rather than idle stops, or alternately a ground feel logic that changes the range so that you have beta on ground but not in air.

Re: Power Lever ranges

Posted: Fri Jan 10, 2020 10:00 am
by johnh
Yes , exactly the same for me but I have managed to use SPAD.next to move into the Ground Fine range, which is why I was asking what the range actually is.