Page 1 of 1
Wind entry in the FMS3000
Posted: Sat Dec 28, 2019 11:02 pm
by matpietsch
Anther flight and another thing tried out that seems not to work:
I tried to enter the winds for the following flightplan:

- 2019-12-28 23_56_35-SimBrief.com - Virtual Flight Planning Solutions.jpg (52.56 KiB) Viewed 1284 times
Entering the winds dor IDA:

- 2019-12-28_23-54-3-833.jpg (254.98 KiB) Viewed 1284 times
The values just do not show op when pressing the LSK right of the waypoint

- 2019-12-28_23-54-7-991.jpg (254.61 KiB) Viewed 1284 times
Ok, ok I have read there is a bug that the values have to be entered the other way around:

- 2019-12-29_0-0-34-254.jpg (265.69 KiB) Viewed 1284 times

- 2019-12-28_23-54-17-572.jpg (253.79 KiB) Viewed 1284 times
Same result, the values do not show up.
Re: Wind entry in the FMS3000
Posted: Sat Dec 28, 2019 11:33 pm
by doodlebug
the 'other-way-round' bug has been fixed for the SP
Re: Wind entry in the FMS3000
Posted: Sat Dec 28, 2019 11:42 pm
by matpietsch
I read the post of Collin but I wanted to show that currently, however you try to enter it, it does not show up next to the waypoint.
Re: Wind entry in the FMS3000
Posted: Sat Dec 28, 2019 11:47 pm
by doodlebug
thanks
Re: Wind entry in the FMS3000
Posted: Sun Dec 29, 2019 1:49 pm
by KenG
I checked this and worked for me (reversing the input.) Make sure you are pressing the Right LSK and not the left one. Left is for ISA and Right for winds.
Re: Wind entry in the FMS3000
Posted: Sun Dec 29, 2019 7:02 pm
by matpietsch
I did press the right one.
Speaking of ISA what is the correct syntax of entering information there?
Re: Wind entry in the FMS3000
Posted: Mon Dec 30, 2019 1:20 am
by matpietsch
I used another flight to enter some winds (delibratly the other way around) and the below is the result. The wind was 001°/ 30 kt.
Maybe you could look into this logic once more there seems to be something wrong.

- 2019-12-29_23-1-1-744.jpg (252.62 KiB) Viewed 1202 times

- 2019-12-29_23-1-4-406.jpg (252.77 KiB) Viewed 1202 times