Screens Flickering, Controls Not Working

[mashilinski]

I think some others have posted about this... However, I am also going to chime in, as this is probably more widespread than realized? Just want the devs to know...

Build: MV_KA350i_v1.0.1_191223
Gfx: sli, 2 1080ti's
Processor: i9 9900k

Screens are flickering:

All screens are flickering. Sometimes weird over-sized reflections are also present on the screens. I believe there are possible issues with SLI and real light. I remember using the 717 a lot (super fun plane) and noticed cockpit lighting flickers, where If I turned the lights on and off a couple times that would solve the problem. But if memory serves me correct, I believe my research led me to see this unfortunately had something to do with real light and running SLI. Trying to trouble shoot flickering with the KA, I reinstalled the former build without real light and true glass (never saw issues with true glass on the 717 running SLI). Still having flickering issues...

Control input for trim not working:

Using Saitek Pro Flight yoke. Using the A1 and A2 button for controlling trim does not work. Key board inputs for trim do not work as well. The only way to control time is to pan down and mouse wheel the trim wheel... No problems in any other planes including the 310R... What gives?

[N4GIX]

Using Saitek Pro Flight yoke. Using the A1 and A2 button for controlling trim does not work. Key board inputs for trim do not work as well. The only way to control time is to pan down and mouse wheel the trim wheel... No problems in any other planes including the 310R... What gives?

I have the same yoke and quad. I have the T1 and T2 that comes suggest for electric elevator trim. This is the horizontal rocker just under the hat switch. No Saitek software installed at all. I just used the P3D assignment's menu.

[mashilinski]

Right, the horizontal rocker below the hat switch... Mine shows A1 and A2 physically labeled. Yes, I do use the P3D assignments menu. So interestingly enough, I have been able to get the trim working with the horizontal rocker. I do have repeatable selected in the P3D assignments menu, however, it seems I have to actually click up or down on the horizontal rocker a few times to get the trim moving, then I can hold it up or down as expected... Not sure, but its certainly working / doable.

[N4GIX]

Actually mine is a vertical rocker. I mis-typed it. I use the horizontal rocker on the right arm for aileron trim.

[mashilinski]

Hahaha right mine is vertical as well. Left side, below hat switch is the vertical. Right side has the vertical, horizontal, and red button (AP disconnect). Using the left side vertical below hat switch.