Blackbird Sims / Milviz Forum Archive

Hi,

I just got a right engine failure approx. 30 minutes after departure in cruise flight at FL270. Before the flight engine condition was good as per MVAMS and no limitations were exceeded except for a few seconds during takeoff.


After closing Prepar3D the engine state is clearly reduced, also for the left engine.


I have absolutely no idea what lead to the failure and need your advise!

Cheers,

Stefan

So far I didn't pay attention to the N1 values in cruise flight and it appears that the issue is related to this.

Can you confirm that continuous N1 above 100% increases risk of engine failure respectively reduces engine state in MVAMS?