Page 1 of 1
Throttles don't move with CH quadrant
Posted: Sat Dec 28, 2019 12:53 am
by don.polidori
Hello, I can't get the throttles to respond, but the prop and mixture levers function. I use FSUIPC to control the yoke and quadrant. All the other axis work as expected except the throttle. They don't move at all in the sim, but the engines do surge when I move the levers, but then fall back to idle. Any thoughts? Thanks, Don
Re: Throttles don't move with CH quadrant
Posted: Sat Dec 28, 2019 6:47 am
by doodlebug
Throttle assignment tools are being added to MVAMS in the upcoming SP
Re: Throttles don't move with CH quadrant
Posted: Sun Dec 29, 2019 2:54 am
by don.polidori
Just FYI for others that may have this issue....I saw on another post that if you set one of the quadrant levers to "throttle", instead of setting 2 levers to "Throttle1" and "Throttle2", you can control them with one lever. Of course, both throttles move together but at least it is workable. Also, still no beta range but the devs are working on that. --Don