Vref Speed Table

[freeze1058]

Hi,

could you post the Vref speeds here plus add them to the manual in a future release? To my knowledge this is a simple landing weight to speed mapping that should not conflict with copyright issues for complex tables/diagrams?!

Thanks,

Stefan

[snapshot21]

+1 for this request, also the takeoff speed table if possible. Thanks!

[freeze1058]

+1 for this request, also the takeoff speed table if possible. Thanks!

Takeoff speeds are already available in the manual, section 11-*

[wells]

VREF FLAPS DOWN

15000 lbs 109 kts
14000 lbs 105 kts
13000 lbs 102 kts
12000 lbs 100 kts
11000 lbs 100 kts
10000 lbs 100 kts

FLAPS UP = VREF + 20

[SAS443]

With stopping distances at 2000ft Pressure Altitude and at Sea Level.

019-.png (108.8 KiB) Viewed 1278 times

[snapshot21]

+1 for this request, also the takeoff speed table if possible. Thanks!

Takeoff speeds are already available in the manual, section 11-*

I did not know how i miss that
Thank you for this!

[freeze1058]

With stopping distances at 2000ft Pressure Altitude and at Sea Level.

Thank you, Niklas.

Could you explain meaning of lines "135" and "Alt."?

[iangrant1981]

With stopping distances at 2000ft Pressure Altitude and at Sea Level.

Thank you, Niklas.

Could you explain meaning of lines "135" and "Alt."?

Part 135 runway requirements I'd guess. Roughly 60% more length required.

Edit, missed that you were asking about "Alt" as well. There are different minimum requirements for alternate airports as well I believe.

[freeze1058]

Roger, thank you.

Would be great if at least the basic Vref data would find the way into the manual as a one-stop shop.

[freeze1058]

Hi,

in version 1.1.27 I still cannot find above Vref table in the manual. This little table shouldn't be too much work to add, right?

Regards,

Stefan