Bug: TCAS settings via MCDU issue

[FinnJacobsen]

When setting up the TCAS via the MCDU "Tune" menu, this only works if the TCAS sub page is selected on the Radio Tuning Unit.

Also on the MCDU TCAS page You can simultaniuosly set f.ex ABOVE/NORMAl or BELOW/NORMAL and maybe even ABOVe/BELOW.
I think only one setting should be allowed.

Finn J

[Taguilo]

When setting up the TCAS via the MCDU "Tune" menu, this only works if the TCAS sub page is selected on the Radio Tuning Unit.

It works fine. You can select TCAS mode from CDU even when RTU page/cursor is not in TCAS section.

Also on the MCDU TCAS page You can simultaniuosly set f.ex ABOVE/NORMAl or BELOW/NORMAL and maybe even ABOVe/BELOW.
I think only one setting should be allowed.

Available options are NORMAL - ABOVE - BELOW - ABOVE & BELOW. Working fine as well.

Tomas

[FinnJacobsen]

When setting up the TCAS via the MCDU "Tune" menu, this only works if the TCAS sub page is selected on the Radio Tuning Unit.

It works fine. You can select TCAS mode from CDU even when RTU page/cursor is not in TCAS section.

Also on the MCDU TCAS page You can simultaniuosly set f.ex ABOVE/NORMAl or BELOW/NORMAL and maybe even ABOVe/BELOW.
I think only one setting should be allowed.

Available options are NORMAL - ABOVE - BELOW - ABOVE & BELOW. Working fine as well.

Tomas

Hmm..
The selections indicated on f.ex the PFD does not reflect the changes done on the MCDU when the RTU isn´t on the TCAS sub page.

[Taguilo]

Ah yes. I now see what you meant.
That’s indeed a bug. Good catch!

Thanks Finn

Tomas