How to start EFIS?

[perstahle]

Just a simple question, how do I get to see the EFIS, the horizon, brown/blue... etc
I can see numbers and digits, but no "glass-cockpit" No FMS rose, or the "ususal" You see at the EFIS screen...
Pleas help the, this brid is a masterpiece!!! I just wonder what I am missing, read the manual, but couldnt figure it out...
So please...
Merry X-mas to You all!
Best Regards
Per

[N4GIX]

Just a simple question, how do I get to see the EFIS, the horizon, brown/blue... etc

Turn on the EFIS switch. Wait about three to four minutes for it to finish self-test and calibration.

[perstahle]

Where is that switch? The EFIS switch?

[Taguilo]

Hi,
What do you mean by EFIS?
Please tell us the steps you are doing. Are you starting in Parked/C&D... which condition?
Are you turning BAT BUS switch on? After that, the other Bat switch that is close to both GEN switches in the three-switch bar (all in pilots side)?

Tomas

[perstahle]

I mean, i dont get to see the gyro, the one you use to see in an EFIS screen, I just see didgets, and letters, no nav rose, no blue/brown circle horizon symbol... I have tried everything... I think, will give it a new try tomorrow morning, can you please give me step by step how to easly make it work?...
Sorry for my stupid question...
Regards
Per

[Taguilo]

Can you do a print screen and post the image here?

Tomas

[perstahle]

i will try tomorrow morning. there must be me, not the plane, causing this error right?

[N4GIX]

Hi,
What do you mean by EFIS?

He means the ESIS Tomas.

Perstahle, the ESIS switch is in the lower left corner of the pilot's knee panel, just under the BAT BUSS switch.

[perstahle]

You are so kind, but I cant get it to work, this is how it looks, no matter what and how I do, I think... What im I missing here?

[perstahle]

This the "best" I can get... Please help me guys!

[perstahle]

And the little ESIS is saying "ATT FAIL" and starts to flicker after a while, and as you can see, the other "big" screens are not "loaded" or not "ready", what ever, I dont understand this, I have done all I can, by the book... (I think), but I am sure that is that little "easy bit" that for som reaseon is missing, or doing wrong???
I am flying off to Svalbard for X-mas today, and without instruments... a bit tricky
Best regards
Per

[perstahle]

I am doing the process from "cold and dark" state, I have tried the "ready to start" also, but no sucsess what so ever...

[jarek]

What Prepar3d version are you using? Is this the latest release 4.5.13.32097?
There is nothing in the model that would allow to turn off only graphic symbols on the screens, so something is wrong with this particular setup.

[perstahle]

Yes i use the latest p3dv4.5... what could be wrong?
Regards
Per

[perstahle]

How do Ypu mean "wrong with this particular setup"?
Please anyone?